Contour Light Switch Cover — Double Toggle + Dimmer
An asymmetric, cast-plaster silhouette — not a machined or symmetrical shape.
Openings and screw positions stay in standard spec, so it still fits a standard box.
Made to order in the finish you choose.
Size
136.04 × 150 × 5 mm
Gang pitch
46.0375 mm (1-13/16 in)
Screws
Four, #6-32, 60.325 mm apart per gang
Fits
Standard two-gang box, one toggle + one rotary dimmer
Why Contour
5.0 mm
Face thickness, vs. ~2.3 mm for a stock plastic plate
13
Cavetto Finishes available on every plate in the line
60.325 mm
Standard device screw spacing — no non-standard fit
Nothing on the silhouette is straight or symmetrical, but the openings and screw positions stay on standard electrical spec underneath it.
Materials & Specifications
- Material
- matte, non-reflective surface; front edge eased into a 3.2 mm chamfer
- Screws
- standard #6-32 wall plate screws; head countersunk 1.7 mm to sit flush — no exposed fasteners
How to Use
Cut the power
Turn off the circuit breaker for the switch or outlet you are replacing. Confirm dead with a non-contact voltage tester before touching any wires.
Remove the old plate
Unscrew the existing cover plate (usually one or two screws). Set the old plate and screws aside — you won't need them.
Seat the new plate
Position the Cavetto plate over the device. The opening should sit cleanly over the toggle slot, rocker face, or outlet slots. No trimming or adjustment needed.
Drive the screws
Use the original wall plate screws (#6-32). Tighten finger-snug, then one quarter-turn with a screwdriver. The countersink is designed for a flush, flat finish — do not overtighten.
Restore power
Turn the circuit breaker back on. The plate is complete — no painting, priming, or finishing required.
Pro Tip
If the plate rocks slightly, the device itself may be crooked in the box. Loosen the device's mounting screws, straighten by eye, and retighten before seating the plate.
